tolorance in config.

[dsimons2710]

hello, can someone explain to me where the tolerance installation can be used for in the integration settings?

I notice that my thermostat does not turn on exactly at the temperature I have set.

maybe it has something to do with this tolerance?

[wtom]

Example: You have 21 degrees temperature and a target also of 21. If you set tolerance to 0.5 then BT will wait until 20.5 to put the TRV to heat.

[dsimons2710]

in my case i have 18.5 temperature and the tolorance is set to 0.5. When i plus the temp to 18.5 BT will switch ON. so the tolorance seems not to work right? my other question is when will it turn on and off by these settings:

set BT to 18.5
tolorance is 0.5

[wtom]

No it will switch it on at 18.0.

Target - tolerance

[dsimons2710]

oke, i did a reload, now it seems to respond correctly.

Temp in room is 18,5, SET BT to go on at 19, TRV= ON now.
final question, when wil the tTRV turn off?

[wtom]

On the target temperature. So at 19 degrees.

[dsimons2710]

could you explain to me when I use the heat button and when I use the eco button.

[dsimons2710]

I have set my eco button to 16.5, will the TRV turn on in eco mode if the temp drops below 16.5, or do I have to be in heat mode?