Temperatures not following target anymore #759
Replies: 3 comments 3 replies
-
Could you also take a screenshot of the BT graphs? Yes if you change the water flow temperature, then BT is a little off, and it takes some time until it's calibrated again. But in AI time based mode it does it by itself. |
Beta Was this translation helpful? Give feedback.
-
Sure, there are the screenshots of the BT graphs. I hope this is what you meant. At the moment the calibration method is "target temperature based" - "normal". I will change one of them to "AI time based" to test this out. |
Beta Was this translation helpful? Give feedback.
-
I struggle with the same problems. Do you found a solution? |
Beta Was this translation helpful? Give feedback.
-
Hello, I have been using better thermostat for a couple of weeks now and recently the actual temperatures of the room was way off the target temperatures. Please see the screenshots:
The yellow part where it says "heating" cannot be correct, as it's currently heating in the living room ("Wohnzimmer") as well as in the office 2 ("Büro Julia") but it's now being shown correctly in the graph. Until yesterday the temperatures were more or less close to the target temperature but yesterday, as you can see in the graphs, it changed and is completely off.
I have however adjusted the flow temperature if my heating system. Does this affect the calibration in any way? Do I have to recalibrate, maybe?
Any help is much appreciated.
Beta Was this translation helpful? Give feedback.
All reactions