Using TCXO with SX1262 #1044
-
|
Hi, I have tried your lib with the SX1261MB2BAS. After calling SX126xSetDio3AsTcxoCtrl, DIO3 is set to the right value. However, when trying the same sample code with a custom pcb (with SX1262 chip), DIO3 is set to LOW instead. Any idea of what is happening? Kind regards, |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
|
Unfortunately, there is not enough information about the issue you are encountering. So, no idea on what is happening. Would it be possible to provide your Please also note that In the future it would be nice if you could post this kind of questions on the project Discussions tab. It is a better place to engage discussions and then we can agree if it is an issue or not. |
Beta Was this translation helpful? Give feedback.
-
|
My apologies for the slow reply; I already solved the issue, the problem was that my CS pin (on the custom board file) was set with inverted logic (high at 0). Kind regards, |
Beta Was this translation helpful? Give feedback.
Unfortunately, there is not enough information about the issue you are encountering. So, no idea on what is happening.
Would it be possible to provide your
sx1262-custom-board.cfile?Please also note that
SX1261MB2BASshield has no TCXO. Did you meantSX1262MBXDAS?In the future it would be nice if you could post this kind of questions on the project Discussions tab. It is a better place to engage discussions and then we can agree if it is an issue or not.
If you don't mind I move this issue to the Discussions tab.