TxPower in ADR Backoff sequence #1525
Replies: 1 comment 4 replies
-
The As you can observe by looking at LoRaMac-node/src/mac/LoRaMac.c Lines 4849 to 4862 in 2bf36bd I think the ADR backoff is correct and is using the right value. Concerning your additional 2 missing cases I think we cannot do much more as the implementation does what the LoRaWAN 1.0.4 specification says. If you don't mind I move this to the Discussions tab as for the moment I do not see an evidence of an issue. |
Beta Was this translation helpful? Give feedback.
-
Hi, this is related to ADR backoff sequence management in file
LoRaMacAdr.c
.When it is time to set TxPower to default, direct PHY layer is used through
RegionGetPhyParam
andPHY_DEF_TX_POWER
but it would be better to useMIB_CHANNELS_DEFAULT_TX_POWER
information (Nvm.MacGroup2.ChannelsTxPowerDefault
) in order to use the value that might have been configured in the device and stored in NVM.In addition, for me there 2 missing cases in general ADR backoff management :
What do you think about that ?
Thanks.
Beta Was this translation helpful? Give feedback.
All reactions