1.74

1.73 2017-03-04 Significant changes to RH_RF24 and its API. It is no longer possible to change the modulation scheme programatically: it proved impossible to cater for all the possible crystal frequencies, base frequency and modulation schemes. Instead you can use one of a small set of supplied radio configuration header files, or generate your own with Silicon Labs WDS application. Changing modulation scheme required editing RH_RF24.cpp to specify the appropriate header and recompiling. convert.pl is now redundant and removed from the distribution.

1.74 2017-03-08 Changed RHReliableDatagram so it would not ACK messages heard addressed to other nodes in promiscuous mode.
Added RH_RF24::deviceType() to return the integer value of the connected device.
Added documentation about how to connect RFM69 to an ESP8266. Tested OK.
RH_RF24 was not correctly changing state in sleep() and setModeIdle().
Added example rf24_lowpower_client.pde showing how to put an arduino and radio into a low power mode between transmissions to save battery power.
Improvements to RH_RF69::setTxPower so it now takes an optional ishighpowermodule flag to indicate if the connected module is a high power RFM69HW, and so set the power level correctly. Based on code contributed by bob.

1.72: In RH_RF24, fixed a problem where some important properties were not …

…set by the ModemConfig. Added properties 2007, 2008, 2009. Also properties 200a was not being set in the chip. Reported by Shannon Bailey and Alan Adamson. Fixed corresponding convert.pl and added it to the distribution.

1.71

Improved support for STM32. Patch from Bent Guldbjerg Christensen.