You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I have set up a set of simple master and slave graph. Basically I just make 3 copies of the Revit advanced structural project. I can run the first run, save the actions. But on the second run, I immediately run into this after the second file is opened. If I click "Enter interactive mode" nothing happens, and slave graph was not run (at least not observed). If I close the Revit application myself, it is the same as the second run.
My setup
Operating System: Windows 10 Home 64bit English
Dynamo version: - 2.0.2 stable build
Revit version & build number: 2018.3.27 English
Housekeeping
I am running the latest DynamoAutomation version
I am running a stable 1.3.x build of Dynamo (no daily build)
I am using Revit 2017 or higher
I do not have multiple Dynamo versions installed on my system
No folder or filename for any Dynamo graph or Revit model in my setup contains whitespaces or special characters
Creating the journal files with debug mode enabled did not resolve my problem
I have set up a set of simple master and slave graph. Basically I just make 3 copies of the Revit advanced structural project. I can run the first run, save the actions. But on the second run, I immediately run into this after the second file is opened. If I click "Enter interactive mode" nothing happens, and slave graph was not run (at least not observed). If I close the Revit application myself, it is the same as the second run.
My setup
Operating System: Windows 10 Home 64bit English
Dynamo version: - 2.0.2 stable build
Revit version & build number: 2018.3.27 English
Housekeeping
Log files can be access from here https://www.dropbox.com/sh/oohmxr9j5kqir87/AACwVRmjAzFSAoAaDdksb56Va?dl=0
The text was updated successfully, but these errors were encountered: