YD-RP2040_Testing

This is a CircuitPython testing repo for the YD-RP2040.

The Firmware used on my board

• CircuitPython Version for My Board

The Board

• Here it is on Aliexpress

Tools Used

• minicom
• circup

Setup

(read this)

Factory Reset Board (recommended, but "you do you").

Put into bootloader mode

1. Press and release the Reset button.
2. Continue holding the Boot button until you see the RPI-RP2 drive appear on your computer.
3. You can now release the Boot button.

Upload the reset firmware(s).

1. Download factory reset firmware into or put it into the drive that appeared.
   • Side note: if your board is str8 messed beyond your fancy... Download this firmware instead to nuke the stuff out of its Flash.

Installing CircuitPython (again recommended, but if you have better firmware or a legit board, this step is not required.)

1. Download the firmware into or put it into the drive that appears with fresh firmware.
2. Wait for its epic uf2 magic to finish ;)
3. This step is optional but it may be what you need, unplug that and replug that simple as it is.

Upload the code

One way is to Navigate to the drive's directory once your device is not in bootloading mode in your shell and git clone this repo;

git clone https://github.com/cloudirector/YD-RP2040_Testing

You can also just Download the repo and extract to the drive.

Usage

(Not yet Completed.)

Click Button Once to start a session.

Once in Session the light should be blinking.

Click and hold on the blue first module, hold on the blank second module.