You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When using an upper sensitivity ratio of 1.5 instead of the default 1.2 ratio with Autosens, the sensitivity shown on AAPS Client never goes above 120% even if it is 150% on AAPS Master (see photo below). It's as if AAPS Client is using the default upper sensitivity ratio of 1.2 instead of the custom chosen one in AAPS Master.
I wasn't able to test the custom lower sensitivity ratio, but the same issue might be present for that value as well. So if I set the lower sensitivity ratio to 0.5 instead of 0.7, then AAPS Client might never show anything below 70%.
The text was updated successfully, but these errors were encountered:
AAPSClient 3.2.0.4
When using an upper sensitivity ratio of 1.5 instead of the default 1.2 ratio with Autosens, the sensitivity shown on AAPS Client never goes above 120% even if it is 150% on AAPS Master (see photo below). It's as if AAPS Client is using the default upper sensitivity ratio of 1.2 instead of the custom chosen one in AAPS Master.
I wasn't able to test the custom lower sensitivity ratio, but the same issue might be present for that value as well. So if I set the lower sensitivity ratio to 0.5 instead of 0.7, then AAPS Client might never show anything below 70%.
The text was updated successfully, but these errors were encountered: