-
Notifications
You must be signed in to change notification settings - Fork 8
/
partlist.txt
18 lines (14 loc) · 1.57 KB
/
partlist.txt
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
1. Male DIN-13 https://www.aliexpress.com/item/DIN-socket-13-PIN-Male-Inline-DIN-13-07F-Plug-Socket-Audio-AV-Connector/32613129753.html
2. Regulator 78L05 - SOT-89 https://www.aliexpress.com/item/Y102-Free-shipping-10pcs-78L05-5V-100mA-SOT-89-SMD-voltage-regulator-78L05-20115/32704576539.html
3. Switch https://www.aliexpress.com/item/10-pcs-Miniature-Slide-Switch-7-Pin-1P2T-SPDT-ON-ON-Right-Angle-SMT-SMD-PCB/32759880849.html
4. TS5V330 - SOP16 https://www.aliexpress.com/item/5PCS-TS5V330DR-SOP16-TS5V330/32718177678.html
5. RCA BTOR1 http://www.tme.eu/en/details/btor1r/rca-connectors/lumberg/btor-1-rot/
6. Trimpot 100R CA6H http://www.tme.eu/en/details/ca6h-100/single-turn-tht-trimmers/acp/ca6h-100/
7. VGA DB15F http://www.ebay.com/itm/170700551912?_trksid=p2057872.m2749.l2649
8. Resistor 100R 1206 https://www.aliexpress.com/item/100pcs-Lot-5-1206-100R-SMD-Resistor-Chip-Resistor-Free-Shipping-YXSMDZ934/32261449239.html
Notes:
BTOR1s can be omitted if you're running VGA on a STE, no need for composite output or two mono audio channels.
If omitting BTOR1s, switch S2 won't be needed. You can run a patch wire if you don't need the switching capabilities. Top pad is video, bottom is autio, middle connected to VIDEO BTOR1.
100R resistor, picture gets quite dark with it so either use a lower value or just add a solder blob. It's there since "all" documentation says it should be.
Trim pots can be omitted as well, but you'll probably want to add resistors instead; top to left.
78L05, there should be no problem transforming 12V to 5V since the TS5V330 has a max power consumption of 3uA.