This firmware makes your PSoC5LP Prototyping Kit (CY8CKIT-059) into an ESP32 programmer with a reset-to-bootloader feature. When you flash a binary by esptools.py, target ESP32 will boot in bootloader mode with no additional external circuit.
PSoC5LP | ESP32 | |
---|---|---|
P12_0 | ← | IO1(TX) |
P12_1 | → | IO3(RX) |
P12_2 | → | EN |
P12_3 | → | IO0 |
GND | — | GND |
Plug the micro USB on PSoC5LP Prototyping Kit (not the TYPE-A on the KitProg) to your host PC.
PSoC5LP Prototyping Kit (CY8CKIT-059)をESP32用のプログラマにするファームウェアです。 esptools.pyでフラッシュするときの、ブートローダモードへの自動リセットに対応しています。 PSoC5LP Prototyping Kit以外に、特別な外部回路は必要ありません。
PSoC5LP | ESP32 | |
---|---|---|
P12_0 | ← | IO1(TX) |
P12_1 | → | IO3(RX) |
P12_2 | → | EN |
P12_3 | → | IO0 |
GND | — | GND |
PSoC5LP Prototyping Kitのmicro USB(KitProg側のTYPE-Aコネクタではありません)をホストPCに接続して下さい。